MATERIAL SAFETY DATA SHEET

 

ALCO PRODUCTS LLC                                                                 Dated:  September 22, 2009

580 ST JEAN

DETROIT MI 48214-3476

313-823-7500                           

FAX: 313-331-4726

 

PRODUCT:  #320     ALCO Asphalt Expansion Joint  

 

SECTION 1     PRODUCT IDENTIFICATION

Trade Name: Asphalt Expansion Joint   

Description:  An Asphaltic Board Material   

Hazardous Rating:  0 – Health     0 – Fire     0 – Reactivity 

                                  (0 = Least; 4 = Extreme)

 

SECTION 2     HAZARDOUS INGREDIENTS

Chemical Name:                             OSHA-PEL                      ACGIH-TLV

   Petroleum Asphalt                  None Established                    5 mg/m3

      CAS #8052-42-4                                                8 HR TWA (Asphalt Fumes)

 

   Limestone                                      N/A                                N/A

      CAS #1317-65-3

 

N/A = Not Applicable 

 

None of the components of this product are recognized as carcinogenic. Asphalt expansion joint is defined by OSHA (29 CFR Part 1910) as an “Article”. A manufactured item which is formed to a specific shape or design during manufacture which does not release or otherwise result in exposure to a hazardous chemical under normal conditions or use.

 

SECTION 3     PHYSICAL/CHEMICAL DATA

Boiling Point:  Not Applicable

Vapor Density (Air = 1):  Not Applicable

Evaporation (BUAC=1):  Not Applicable

Appearance: Black board material in various thicknesses and lengths   

 

SECTION 4     FIRE & EXPLOSION DATA

Flash Point:  > 400° F. 

Upper Explosive Limit (UEL):  Not Applicable  

Lower Explosive Limit (LEL):  Not Applicable  

Special Fire Fighting Procedures:  Treat as fuel oil fire.

Extinguishing Media:  Water Fog, Chemical Foam or Carbon Dioxide

Flammability:  NFPA – None

                     DOT – Not Regulated

 

SECTION 5     REACTIVITY DATA

This material is stable.

Materials to Avoid:  Strong Oxidizers

Hazardous Polymerization:  Will not occur

Decomposition/Combustion Product:  Combustion may yield Carbon Monoxide, Carbon Dioxide and
   incomplete combustion.  

 

SECTION 6     HEALTH HAZARD DATA

Inhalation – Under normal use, this product is not hazardous via inhalation.

Skin – May cause mechanical irritation.  

Ingestion – This product has low order of toxicity. If symptoms of gastrointestinal irritation develop,
   seek medical attention.  

Eyes – May cause mechanical irritation.

Signs & Symptoms:  None with normal product use.

Aggravated Medical Conditions:  None known with normal product use.

Other Health Effects:  From skin painting studies in laboratory animals, it has been concluded that some
   asphalts may possess weak carcinogenic activity. This means that workers who practice poor personal
   hygiene, and who are repeatedly exposed by direct skin contact with petroleum asphalt over many
   years, may potentially be at risk of developing skin cancer. Intermittent or occasional skin contact
   with petroleum asphalt is not expected to have serious health effects as long as personal hygiene
   measures, such as outlined in this material safety data sheet, are followed. In addition, asphalt vapors
   may container polycyclic hydrocarbons, some of which are known to be carcinogenic. Therefore,
   prolonged breathing of vapors should be avoided.

 

SECTION 7     FIRST AID PROCEDURE

Skin:  Flush with water to remove particulates. Wash affected area with soap and water if available.  

Eyes:  Flush with large amounts of water to remove particulates. If condition persists, consult a
   physician.

Inhalation:  None normally required.

Ingestion:  None normally required.

 

SECTION 8     PREVENTATIVE MEASURES/SAFE HANDLING & USE

Leak and Spill Procedure:  Not applicable. Product is a solid.

Waste Disposal:  In some areas this product may be considered non-hazardous special waste if disposed
   of in a permitted landfill. Consult Federal, state and local regulations.

 

SECTION 9     CONTROL PROTECTION DATA

Ventilation:  Normally not needed.

Gloves:  Leather type work gloves recommended

Eye Protection:  Safety glasses

Additional Personal Protection Equipment:  Requirements must be supplied by the user, depending
   on use conditions.

 

SECTION 10     REGULATORY INFORMATION

Reportable/Quantity:  None

RCRA Hazardous Waste No.:  None

DOT Proper Shipping Name: Not regulated by DOT

Identification Number:  NMFC #170570

 

SECTION 11     SHIPPING INFORMATION

DOT Shipping Description:  Not Regulated  

ID #:  None

Labels Required:  None

Packaging Requirements (49 CFR)(Specific):  None

 

SECTION 12     USER RESPONSIBILITY

This product material safety data sheet provides health and safety information. The product is to be used in applications consistent with our product literature. Individuals handling this product must be informed of the recommended safety precautions and must have access to this information. For any other uses, exposures must be evaluated so that appropriate handling practices and training programs can be established to ensure safe work place operations. Please consult your local sales representative for any further information.

 

SECTION 13     CLEAN UP AND DISPOSAL

Practice good personal hygiene. Launder contaminated clothing before reuse. Use control protection such as chemical splash proof goggles, oil resistant gloves, barrier cream. Clean tools and equipment with kerosene, adhering to manufacturer’s precautions. DO NOT USE GASOLINE OR NAPHTHA. Follow proper container management in disposing of containers. CERCLA amendment on disposal of containers should be followed.

 

SECTION 14     DISCLAIMER

The information set forth herein is believed to be accurate but is not warranted to be, whether originating with ALCO PRODUCTS LLC or not. Recipients are advised to confirm in advance of need that the information is current, applicable and suitable to their circumstances.

 

This Material Safety Data Sheet supersedes all other previously dated sheets for this product.